User's Manual

The above diagram is one example of a recommended installation. Other

variations are possible. Consult your local mobile electronics installer.

WARNINGS

• The B800-1900-1F complies with FCC regulations. Follow all guidelines and

read this information completely before beginning the installation procedure.

Never operate the system in an unintended application.

• All cellular phones in the vicinity of the amplifier should be turned off during

installation. Only after unit is installed should cellular phones be turned on

and tested with the system.

• Make sure to connect to a 12-Volt source that is not providing power when

vehicle is turned off. Otherwise battery will drain.

• Unit must first be turned on without antennas connected for system

calibration. Ensure that the LED light on the Amplifier Unit is Green

before connecting antennas. Amplifier Unit must remain on while

connecting antennas.

• Only th

e provided power cable is to be used with the Call Capture systems.

Using any other power cable will harm the system. The Call Capture’s warranty

will be voided if any other power cable is used.

• Only the antennas provided with the Call Capture system may be used. Use of

any other antenna could adversely impact the performance of the system,

cause damage to the unit and would void the warranty.

• Changes or modifications not expressly approved by Richardson Electronics

will void the user’s authority to operate the equipment.