User manual

IRIS Configuration - Manual
IRIS-Confi g-Manual-1a
18
Remote connection via radio
Connect the PC and the other IRIS-unit with a serial cable. Make sure that the serial interface
settings are the same on both the PC and the IRIS-unit.
Via a standard IRIS-unit
A standard IRIS-unit need to know the identifi cation number of either the IRIS-unit to be
setup or another IRIS-unit within the same network.
If the standard IRIS-unit already is a part of the network, no more preparations are necessary.
If it is not some small adjustments have to be made in the IRIS-unit connected to the PC:
· If the two units are within radio range:
o Set the IRIS-unit that is to be confi gured as either Upper or Lower unit in IRIS-unit that
are connected to the PC.
· If the two units are not within radio range:
o Choose a unit, with in range and that are connected to the network, and set it as Upper unit
in IRIS-unit that are connected to the PC.
Via an IRIS setup unit
The IRIS setup unit needs to be within radio range of either the IRIS-unit that is to be confi g-
ured or the network that the IRIS-unit is a part of.
Send setup to the IRIS-unit
· Press the “Send to IRIS” button on the IRIS unit tab.
· Check the parameters that are to be sent and press the “Ok” button
· Wait until the transmission is ready.