Datasheet

22
DESCRIPTION, PURPOSE OF USE
• 19“ free-standing cabinet with IP20 protection.
• Cabinet includes 4 sliding vertical rails for device mounting (6 rails for cabinets deeper than 800 mm).
• Cabinet construction:
– Welded steel frame with removable side panels.
– Single or double doors in variants fully-metal, perforated (80% air permeability) or glazed with safety tem-
pered glass 4mm. They can be on the front or back of the cabinet.
• Max. permissible load of the door is 20 kg.
• Min. thickness of the surface fi nish is 65 μm.
• These cabinets are intended for installation data and telecommunication devices and their distribution systems.
• The frame of the cabinet and all the removable parts (side and rear covers, doors…) are connected with earthing
cables that have to be properly fi xed and inserted into connectors during all the time when using the cabinet.
• There is one M8 screw placed on the bottom part of the cabinet as an earthing main point.
• Cable openings covered with breakout-type blanking panels are placed in the top and the bottom part of the
cabinet.
OPERATION CONDITIONS
• Operation environment:
– Offi ce.
– The cabinet is not intended for outdoor installations and for installations in environment that can infl uence
negatively the functionality of the cabinet and the mounted devices (e.g. environment with danger of explo-
sion or humid and wet surroundings).
• Must be protected against:
– Mechanical damage.
– Improper manipulation.
– A different usage than the cabinet is intended for.
• Improper manipulation is especially:
– Overloading (maximum recommended load exceeding).
– Device installation that can infl uence negatively operation and function of the cabinet or the installed equipment.
– Change of the construction or design of the cabinet.
INSTALLATION OF THE CABINET
• To ensure the maximal recommended load, it is necessary to distribute the load equally.
• Place the cabinet on a fl at fl oor and compensate an eventual small roughness with the nivelation feet.
• To avoid dust penetration in a case where cables lead through some of the cable openings, it is possible to seal
it with a blanking panel with a brush or secure by plastic frame (both are part of the cabinet supply).
ENVIRONMENT PROTECTION
• All parts are made of recyclable materials and after its discard, it is necessary to dispose the cabinet according
to valid regulations.
CERTIFICATE AND CONFORMITY
• This product is certifi ed by ITI TÜV, certifi cation number 06.140.501/r1, date 03/01/2013 and is fully in conformi-
ty with ČSN EN 62208 ed.2:2012(EN 62208:2011).
RMA
RMA FREE-STANDING CABINET