User Manual

FT7000

- SITE PREPARATION AND INSTALLATION GUIDE

The optional Envelope Depository Unit (EDU) contains an Envelope Transport Mechanism, Shutter As-

sembly, and an Envelope Deposit Bin (secure). The Envelope Supply Unit holds approximately 200 enve-

lopes. When loading envelopes, alternate every 50-100 with the flaps UP. For example, load 50 with flaps up

facing Left, then next 50 with flaps facing Right. The envelope size requirements are as follows:

TESTING /ADJUSTING FOR ENVELOPE THICKNESS

 Open the upper left rear cabinet door and pull the Envelope Depository slide tray out fully.

 Following the instructions on inserting envelopes (label on unit) , load twenty-five (25) envelopes

(flaps up) into the supply unit bin.

 Access Management functions and from the Main menu screen select DIAGNOSTICS > ENVELOPE

DEPOSITORY > ENVELOPE DISPENSE AND RETRACT TEST. The test dispenses an envelope and then automati-

cally retracts it into the depository storage bin (normal operation). Note: With the depository unit tray

extended out, the envelopes will fall on the floor. DO NOT refill supply bin with these envelopes.

 After the test is complete, press <1> to repeat. Perform this test a minimum of five (5) times.

 If one (1) envelope has repeatedly been dispensed/retracted, the check is complete. If the envelope

has double-fed OR has not fed, proceed with the next procedures.

TEST DISPENSING / RETRACTING ENVELOPES

After installation is complete, it is recommended that you test and verify that the unit dispenses and

accepts only one (1) envelope at a time. To perform an operational check, the unit must be powered up and

you have access to Management functions:

tnemeriuqeReziSepolevnE

htgneL htdiW ssenkcihT

muminiM]"19.5[mm051]"57.3[mm59

]"72.[mm7

mumixaM]"6.9[mm442]"52.4[mm801

)mm1.832xmm8.401(epolevne01#asiezisdednemmoceR:etoN