Manualshelf

User Manual

ManualsBrandsTriton ManualsEquipmentFT7000XP Installation Manual
41424344454647484950
43
FT7000
XP
- SITE PREPARATION AND INSTALLATION GUIDE
STEP 7: INSTALLING / SECURING CONTROL PANEL COLLAR
(Outside facility - Control panel extended / open). Locate the control panel collar assembly.
Align the trim tabs located on back of assembly (2 - each side) with the slotted openings of the control panel.
Insert tabs and push down slightly.
(Top of control panel) Loosen thumbscrew and remove enclosure lid shown to gain access to
control panel GPIO docking board.
Connect the wires from the collar assembly to the connector shown. Reinstall the enclosure lid.
(Inside control panel) Secure the collar assembly with eight (8) screws provided. Figure below
shows location of screw holes.
CONTROL PANEL COLLAR