User Manual

40
INSTALLING UNIT / COLLAR HARDWARE
SITE PREPARATION / INSTALLATION
STEP 1:
Slide the unit’s tube section through wall opening. Let it
protrude slightly out the front (exterior) wall.
STEP 2:
Start the nuts supplied to each of the four (4) collar brackets (2 nuts per bracket). Temporarily slide the
collar brackets to the tube front. Bracket P/Ns are listed in table below. Attach the top/bottom pieces first,
then sides. DO NOT secure pieces together at this time.
NOTE
DO NOT install the collar bracket hardware (4-
brackets) or control panel collar prior to mov-
ing unit through wall opening.
snoisnemiDstekcarBralloC
noitangiseD htgneL htdiW noitangiseD htgneL htdiW
poT
83210-11030N/P
"03
)mm267(
"4/3-4
)mm021(
tfeL
73210-11030N/P
"61/11-73
)mm759(
"61/11-1
)mm44(
mottoB
93210-11030N/P
"03
)mm267(
"8/7-3
)mm89(
thgiR
85210-11030N/P
"61/11-73
)mm759(
"61/5-2
)mm85(