Models RL/FT5000XP QUICK REFERENCE CARD FT5000XP RL5000XP THIS AREA FOR SERVICE PROVIDER CONTACT INFORMATION: TDN 07102-00061
MANAGEMENT FUNCTIONS ACCESS INSTRUCTIONS 1. ATATM WELCOME SCREEN, PRESSAND HOLD DOWN KEY (LOWER-RIGHT CORNER OF KEYPAD), PRESS <1> KEY, THEN RELEASE BOTH KEYS. THE SECURITY LOGIN SCREEN WILL BE DISPLAYED. 2. ENTER THE 2-DIGIT USER ID. PRESS KEY. ENTER THE USER PASSWORD AND PRESS KEY. THE MAIN MENU IS DISPLAYED. RESTART / SHUTDOWN TERMINAL RESET ATM: FOLLOW ACCESS INSTRUCTIONS TO ENTER MANAGEMENT FUNCTIONS. SELECT SYSTEM PARAMETERS, THEN RESTART TERMINAL.
REPLENISH CASSETTE(S) THE REPLENISH CASSETTE(S) FUNCTION ALLOWS USER TO UNLOCK/LOCK THE CASSETTE(S) FOR CURRENCY REPLENISHMENT. ¾ GO TO MAIN MENU FUNCTIONS USINGACCESS INSTRUCTIONS. SELECT TERMINAL SETTLEMENT FUNCTIONS. CHOOSE REPLENISH CASSETTE(S). ¾ A SCREEN WARNINGAPPEARS THAT THE TIMEOUT FUNCTION NORMALLY ASSOCIATED WITH MANAGEMENT FUNCTIONS IS DISABLED. PRESS <1> TO CONTINUE. ¾ WAIT FOR ALL CASSETTES TO BE UNLOCKED. A SCREEN WILL BE DISPLAYED THATALL CASSETTES HAVE BEEN UNLOCKED.
REPLENISHING CASSETTE(S) STEP 1 ACTION STEP UNLOCK/OPEN CABINET. GRASP THE CASSETTE HANDLE WITH ONE HAND WHILE HOLDING THE MECHANISM WITH THE OTHER. PULL THE CASSETTE OUT SLIGHTLY, THEN PLACE ONE HAND UNDERNEATH AS YOU SLIDE IT OUT. ACTION 5 EXTEND THE “PAWLS” FULLY (INSERT) ON THE PUSHER PLATE. 2 PLACE CASSETTE ON A LEVEL SURFACE. INSERT THE KEY INTO THE CASSETTE LOCK AND TURN CLOCKWISE. PRESS GREEN RELEASE BUTTON TO RAISE LID. 6 CLOSE THE CASSETTE LID TO ITS LOCKED POSITION.
REPLACING RECEIPT PRINTER PAPER (RLXP) STEP ACTION STEP ACTION STEP ACTION 1 CUT REMAINING PAPER TO ALLOW REMOVAL. 2 PRESS FEED BUTTON TO CLEAR PAPER FROM PAPER PATH. 3 LIFT SPINDLE TO REMOVE PAPER ROLL AND SPINDLE. Paper feed button 4 REMOVE OLD PAPER ROLL. PLACE SPINDLE IN NEW PAPER ROLL. 5 PLACE NEW PAPER ROLL ON BRACKET. MAKE SURE PAPER FEEDS FROM TOP! 6 FEED END OF PAPER OVER THE BAR INTO FEED SLOT. 7 PAPER WILL FEED AUTOMATICALLY INTO PRINTER.
REPLACING RECEIPT PRINTER PAPER (FTXP) STEP ACTION STEP ACTION STEP ACTION 1 CUT REMAINING PAPER TO ALLOW REMOVAL. 2 PRESS FEED BUTTON TO CLEAR PAPER FROM PAPER PATH. 3 LIFT SPINDLE TO REMOVE PAPER ROLL AND SPINDLE. Paper feed button 4 REMOVE OLD PAPER ROLL. PLACE SPINDLE IN NEW PAPER ROLL. 5 PLACE NEW PAPER ROLL ON BRACKET. MAKE SURE PAPER FEEDS FROM BOTTOM! 6 FEED END OF PAPER INTO FEED SLOT. 7 PAPER WILL FEED AUTOMATICALLY INTO PRINTER.
