User Manual User guide

62
moDel rl/Ft5000
XP
USer mAnUAl w/PriSm
tm
nDc emUlAtion
AcceSS inStrUctionS:
1. Enter the SUPerViSor moDe by opening the control panel. The Supervi-
sor “Select” menu should appear on the display.
2. Refer to the applicable Figures below (by model type). Lock the Prism
NDC application in SUPerViSor moDeby depressing the “Supervi-
sor” rocker switch so the raised RED edge on one side of the switch
is NOT visible. This will prevent the Prism
TM
NDC emulation applica-
tion from exiting to the cUStomer (rUn) moDe”. In the RL5000
XP
or
the FT5000
XP
, the “Supervisor” switch is located on the Controller PC
mounting bracket.
FT5000
XP
Supervisor
Switch - Raised
Red Edge
RL5000
XP
Supervisor Switch -
Raised Red Edge
SUPERVISOR MODE