User Manual User guide

30
Model rl/Ft5000
XP
USer ManUal w/PriSM
tM
ndc eMUlation
8. If the paper is not automatically
taken-up by the printer, check the
tension roller lever on the printer
chassis. Pull the pin located on the
right side of the printer bracket
shown. Rotate the assembly
towards the front of the control
panel.
9. The blue tension lever is located
on the left side. It must be in
the closed position (blue lever
facing towards the right). If not,
just move the lever (moves in 3
positions) to the correct position.
Close the cutter assembly and
retry to feed the printer paper. If
successful, continue with Step
10. If the paper is not taken
up automatically, contact your
service provider.
10. Make sure the supervisor switch
is in the SUPerviSor position and
then close the control panel. From
the Prism
TM
NDC Supervisor
main menu (Se l e ct), select
conFigUre > Print conFig to
perform an offline test of the
printer.
11. Open the control panel and ip
the supervisor switch to the rUn
position. Close and lock the
control panel.
Release pin