User Manual Instruction Manual

28
MODEL RL/FT5000
XP
USER MANUAL
INTRODUCTION
This section of the manual covers pre-
ventive and corrective maintenance
procedures appropriate for user person-
nel. The following areas are covered:
1. R
EPLENISHING PAPER RL/FT
XP
(RECEIPT PRINTER). Describes how
to replace a spent receipt paper roll.
2. R
EPLENISHING PAPER (JOURNAL
PRINTER). Describes how to
replace the spent journal paper roll.
3. L
OADING INK CARTRIDGE (JOURNAL
PRINTER). Describes how to load
the printer ink cartridge.
4. C
LEANING THE ENCLOSURE. The
proper way to clean the ATM
housing and displays..
5. C
ARD READER CLEANING. The
recommended card reader cleaning
technique.
*IMPORTANT*
Only qualified service personnel
are authorized to repair or ser-
vice the terminal. Should a mal-
function occur, DO NOT attempt
to service the unit yourself! Con-
tact your Triton certified service
provider!
***WARNING***
The control panel for the RL
XP
is
provided with a pneumatic piston
to prevent the door from extend-
ing too far when opening and pro-
vides some dampening when being
closed. Do not force the piston
when closing the control panel!
REPLENISHING RECEIPT PAPER
(RL5000
XP
)
1. Open the top of the ATM by
unlocking the top enclosure and
pulling the hinged door forward.
NOTE: This operation must be com-
pleted with the AC power applied to
the ATM.
2. If paper remains on the roll, cut
the paper between the roll and the
input to the printer with a pair of
scissors.
* NOTE *
Triton recommends the use of 20#
thermal printer paper (Triton P/N
05403-00053). This receipt paper has
been shown to improve performance
and reliability.