User Manual Instruction Manual

113
MANAGEMENT FUNCTIONS
4. REPORT DISPENSER COMPLETION STATUS. This function allows user to set
the wait for bills taken option. The available values are described below.
Press <4> on the keypad to toggle through the options.
 WHEN BILL(S) PRESENTED (DEFAULT). When selected, the Prism software
report the solicited completion status to the host application as soon as
it presents the bill(s) to the customer successfully.
However, if an error occurs while presenting the bill(s), the solicited error
status will be reported to the host.
If the customer fails to take the bill(s) or any error occurs after the bill(s)
successfully presented, there will be no solicited error status sent to the
host.
 WHEN BILL(S) TAKEN. When selected, the Prism software waits for the
customer to remove the cash. If the customer fails to remove the cash
within the specified time (timer 5 and 7 that the host downloads to the
ATM), the Prism software reports the status to the host application.
5. SELECT PARTIAL DISPENSE STATUS. The solicited status message sent to
the host for the dispenser contains a Partial Dispense Status (byte 3).
This option determines the value of this byte for cassette low and out
situations. Press <5> on the keypad to toggle between the available
settings:
 RETURN ‘5’ FOR LOW AND OUT (DEFAULT). The Partial Dispense status
byte will always be ‘5’ for cassette low and cassette out messages sent to
the host.
 Return ‘3’ for Low and Out. The The Partial Dispense status byte will
always be ‘3’ for cassette low and cassette out messages sent to the host.
 RETURN ‘5’ FOR LOW AND ‘3’ WHEN ALL CASSTTES ARE OUT. The Partial
Dispense status byte will be ‘5’ for cassette low and cassette out messages
sent to the host. However, when the last casette goes to a cassette out
situation, the status byte will be ‘3’.
6. SAV E GENERAL SETTINGS AND EXIT. Allow user to save all the displayed
settings and exit from menu. Press <6> on the keypad to save and exit.
3. AUTOMATIC CASH RETRACT. This function allows user to set the retract
cash option. When enabled, the Prism software retracts the cash back
into the ATM when the customer fails to remove within the specified host
timer. Press <3> on the keypad to toggle between enabled (check) or
disabled (uncheck). When disabled, menu option (4) - ‘Report Dispenser
Completion Status’ will automatically be disabled.