User Manual User guide

8
MODEL FT5000 (X2) USER MANUAL
INTRODUCTION
This section describes the basic operation of the terminal. The following topics are covered:
1. CONTROL PANEL LAYOUT. Describes the layout of the terminal’s control panel.
2. KEYPAD OPERATION. Describes the use of the function, alphanumeric (main), and on-screen keypads.
3. REAR SERVICE PANEL (RSP). Describes the RSP and its hardware.
4. MENU-BASED OPERATION. Gives a general overview of the terminal display interface.
5. CUSTOMER TRANSACTIONS. Summarizes the actions involved in typical customer transactions. In addition,
the voice-enabled transactions feature is described.
CONTROL PANEL LAYOUT
The user interface of the terminal consists of the
LCD screen, receipt chute, card reader, speaker,
headphone jack (visually impaired), and 24 keys on
three keypads. The Function keys are arranged in
two four-key groups, one group on either side of
the LCD display. The main keypad consists of 10
alphanumeric keys, two arrow keys and four large
control keys, all located in a 16-key group beneath
the LCD screen.
The main keypad and control keys have an integral
raised Braille symbol to conform to the requirements
of the Americans with Disabilities Act (Figure 2-1).
Figure 2-1. Control panel layout.
LCD screen
Receipt
chute
Card
reader
Main keypad
Bill chute
Function
keys