User guide

TRITON SYSTEMS, INC.
SECTION 5 - MANAGEMENT FUNCTIONSOPERATION MANUAL - MODEL 97XX-Series
5-118
9700-SERIES
9705-SERIES
9710-SERIES
9750-SERIES
DIAL MODE
FACTORY DEFAULT: ‘DTMF’
ACCESS INSTRUCTIONS:
1. Select TERMINAL CONFIGURATION from the MANAGEMENT
FUNCTIONS menu.
2. Select SET TERMINAL PARAMETERS.
3. Select TELEPHONE.
4. Select the MODEM SETUP option.
5. Select DIAL MODE.
D
ESCRIPTION:
The modem is configured to dial in either the touch-tone mode
(DTMF), or in the rotary (PULSE) mode. Consult with the local
phone company to determine which option is supported. After se-
lecting the dial mode, be certain to execute the RESET/TEST
MODEM function. The new dial mode does not take effect until
you do this. The factory default for the function is DTMF.
ERROR CONDITIONS:
If the local phone exchange does not support touch-tone, and the
terminal is configured for DTMF mode, no calls will be completed.
Rotary will work on touch-tone systems, but should not be used if
touch-tone is available. Rotary mode will dial much slower than
DTMF.