User guide

TRITON SYSTEMS, INC.
SECTION 5 - MANAGEMENT FUNCTIONSOPERATION MANUAL - MODEL 97XX-Series
5-112
9700-SERIES
9705-SERIES
9710-SERIES
9750-SERIES
PRIMARY NUMBER
FACTORY DEFAULT: NONE
ACCESS INSTRUCTIONS:
1. Select TERMINAL CONFIGURATION from the MANAGEMENT
FUNCTIONS menu.
2. Select SET TERMINAL PARAMETERS.
3. Select TELEPHONE.
4. Select the PRIMARY NUMBER option.
DESCRIPTION:
The Cash Dispenser communicates to your host processor over a
dial up phone line. The phone number of the processor must be
entered before live transactions can be done.
When this function is selected, the current phone number is dis-
played (if nothing appears on the screen, no number is set). Se-
lect CHANGE to blank the current entry, and then enter the de-
sired phone number. The phone number may be up to 15 digits
long. It can also contain a dialing prefix, such as a ‘9’ for an out-
side line, if necessary. If you need to pause after the prefix, place
a comma in the number for a two-second delay at that point. Press-
ing the <CTRL> key first, then the <0> key, followed by the <RIGHT
ARROW> key will select the comma character. Make sure to en-
ter the long distance prefix ‘1’ if you are dialing an 800 number or a
toll long distance number. Do not enter dashes in the number.
E
RROR CONDITIONS:
The Cash Dispenser will not process transactions if the phone num-
ber has not been entered or has been entered incorrectly. In such
cases error code “185 - Phone Number Not Configured”, will be
received.