User Manual User guide

16
MODEL 9100 USER MANUAL
Main menu screen (multihost).
INTRODUCTION
This section describes the Management Functions available with the ‘MASTER’ password for accessing
the ATM. When the Customer Welcome screen is displayed, you can access the Management Functions
menu by following the procedure described next.
ACCESSING THE MANAGEMENT FUNCTIONS MENU
1. Press and hold down the <CTRL> key; while holding down the <CTRL> key, press the <1> key.
Release both keys. After a moment the top menu will be displayed.
2. At the top menu, select MANAGEMENT FUNCTIONS by pressing the key next to Management Functions
option.
3. Enter the user password at the password entry display.
Figure 3-1. Main menu screen (non-multihost).
CHANGE DEFAULT PASSWORDS
A new error code (246) has been created for when the terminal’s MASTER and/or ADMINIS-
TRATION password(s) are in the default state. The terminal will detect this condition and go
out of service. On the “Out of Service” screen, no error information will be displayed. This
error code will not reset until the Master and/or Administration passwords are changed from
their default state.
The default MASTER password is ‘123456’ and the default ADMINISTRATION password is
‘987654’.
* IMPORTANT *
NEVER USE THE IDENTICAL PASSWORD FOR BOTH MASTER AND ADMINISTRATION!