Installation Manual Instruction Manual

22
MODEL 9100 INSTALLATION MANUAL
9. Route the serial communications cable and power cable through the Ty-wrap loop located on figure
below. Plug the data cable into jack J11. Plug the DC power connector into jack J12 Pull Ty wrap to
secure cables to dispenser.
Cable tie wrap near data / power connections.
Important
After the dispenser and cables have been installed, rotate the turntable a few
times to ensure the cables do not bind or are placing stress on the dispenser
connectors.
10. Next, plug the ground wire to the dispenser as shown. Use a Ty-wrap to secure.
Ground wire connection
Ty-wrap