/Installation Manual Instruction Manual

55
MANAGEMENT FUNCTIONS
TRITON CONNECT
ALARM NUMBERS
DESCRIPTION:
The ALARM NUMBERS are provided by
your Processor/Host Network
Administrator. If you are using TCP/
IP as your communication type, you
will need to enter ALARM TCP/IP
ADDRESSES. The first part of the address
consists of a sequence of four groups
of numbers. Each group can be up to
three digits long, and each group is
separated by a period (dot character),
as in this example: 123.3.01.99 The
second part of the address is a Port
Number, consisting of four (4) digits or
less, separated from the first part by a
comma (“,”) character, as in this
example: 123.3.01.99,9043.
Follow these steps to initially enter or
change the PRIMARY ALARM NUMBER
(ADDRESS):
$ Select <Change> to blank the
current entry, if necessary.
$ Enter the first group of numbers in
the TCP/IP Address using the main
keypad keys.
$ Enter a ‘dot’ character by pressing the <Control> key, then the <0> key
Twice to select the period’, then the <Right Arrow> key to lock it in.
$ Repeat Steps 2 and 3 for the second and third group of numbers in the TCP/
IP Address.
$ Enter the fourth group of numbers in the TCP/IP Address.
$ Enter the comma (“,”) character by pressing the <Control> key, then the
<0> key Once to select the comma. Press the <Right Arrow> key to
lock it in.
$ Enter the PORT NUMBER. Select <Enter> to save the Primary Alarm TCP/
IP Address entry or <Cancel> to discard the changes. Repeat steps for
BACKUP A LARM NUMBER (ADDRESS) entry.