Owner manual

LIGHTED LOWTOPPER - FIELD INSTALLATION GUIDE

1. Lay the topper assembly on a flat

surface, rear side up, as shown in

Figure 1. Note the location of the

dome plug. You will remove this

plug in a later step, to allow the

power cord to be routed out the

back panel of the topper assembly.

2. Remove the screws that hold the

front and rear panels of the

assembly together. See location of

screws in Figure 1.

Figure 1. Rear panel of topper

assembly, showing location of screws

and dome plug.

Dome Plug

CONNECTING THE TOPPER POWER CORD FOR EXTERNAL ROUTING

(AC ASSEMBLY ONLY)

Plug the AC power cord into the ATMs power supply, as shown in Figures 8a

-8c.

AC CONNECTIONS (BALLAST/BULB TOPPER)

Figure 8b. Model 97XX

Figure 8a. Model 9100

Figure 8c. Model RL5000