Cordless Drill User Manual
• Any damage to this tool
should be repaired and carefully
inspected before use, by qualified
repair personnel.
• Have your power tool serviced
by a qualified repair person using
only identical replacement parts.
This will ensure that the safety
of the power tool is maintained.
• Triton Manufacturing & Design
Co. will not be responsible for
any damage or injury caused
by unauthorised repair or
mishandling of the tool.
POWER CORD
MAINTENANCE
If the supply cord needs replacing,
the task must be carried out by
the manufacturer, the manufacturer’s
agent, or an authorised service
centre in order to avoid a safety
hazard.
CLEANING
• Exterior plastic parts may be
cleaned a damp cloth and mild
detergent. Although these parts
are highly solvent resistant,
NEVER use solvent.
• Dirt and grease may be removed
from the exterior of the charger
using a cloth or soft non-metallic
brush. Do not use water or any
cleaning solutions.
Disconnect the charger
from the power point
before cleaning.
SERVICE & MAINTENANCE
Service & Maintenance
11
or near heat sources.
• Avoid charging your screwdriver
in temperatures below 0°C (32°F)
and over 40°C (104°F).
1. Push the
connection pin
on the charger (6)
into the charger
connection point
(4) on the base of
the screwdriver handle.
2. Connect the mains plug of the
charger to a suitable power point.
The red LED charge
light indicator (5) will
illuminate for the duration of
the charge cycle.
3. The charge cycle should take
between 3 and 5 hours, after
which the charge light indicator
(5) will switch off.
The charger should
be disconnected from
mains power on completion
of the charge cycle. Do not
exceed 12 hours of connection
to mains power.
4. Disconnect the charger from
the power point before removing
the connection pin from the
screwdriver.
While charging, the charger
and the screwdriver may
become warm to touch. This is
normal and does not indicate
a problem.
Do not attempt to charge
the screwdriver with any
charger other than that supplied
with the tool. Contact your local
Triton office if charger replacement
is required.
SHAFT LOCK
This screwdriver
is fitted with an
automatic shaft
lock. With the
trigger switch
dis-engaged it can
be used for manual screwdriving.
Functions
10