Owner Manual

7
TDM ENHANCEMENT KIT INSTALLATION PROCEDURES
11. Route the power and data cables
through the tie wrap loop and
connect to the dispenser board.
(Figure 9)
12. Pull the tie wrap taut until the
cables are secured in place. (Figure
10)
13. Rotate the dispenser 180°
counterclockwise back to the
operate position. Installation of
the Enhancement kit is complete.
Power cable
Data cable
Tie wrap
cables
Fig. 10. Power and data cable
secured with tie wrap.
** IMPORTANT **
The power and data cables MUST be
secured to the dispenser with the tie
wrap provided. Failure to do so may
cause damage to the connectors and/
or cables.
Fig. 9. Route cables through tie
wrap and connect to dispenser..
10. Route the power and data cable
through the clip and snap in place.
(Figure 8)