Owner Manual

TDM ENHANCEMENT KIT INSTALLATION PROCEDURES

Installing the TDM Enhancement kit for Models 9705/RL5000 ATMs

Follow these steps to install/secure the protective plastic cover, cable clip, and

power/data cables to the dispenser..

1. Open the control panel hood. Turn

the power switch on the power

supply to the OFF (0) position.

2. Open the dispenser vault door.

Slide the dispenser tray out to its

fully extended position. (Figure 1)

3. Locate the spring-loaded locking

pin on the underside of the

dispenser tray. (Figure 1) Pull pin

down and slowly turn the

dispenser 180° clockwise so the

cassettes are facing towards the

front. Release pin (tray should lock

in place). See Figure 2.

4. Disconnect the power and data

cables from the dispenser.

Fig. 1. Pull locking pin.

Fig. 2. Rotate dispenser.

6. Place the clear plastic cover over

the dispenser circuit board as

shown in Figure 5. Ensure wires

leading to other components are

clear of being “pinched” before

securing cover with screws.

7. Install the 2 Torx screws using a T-

6 Torx driver to secure the plastic

cover to the dispenser. Figure 5

shows the screw locations.

5. Using a T-10 Torx driver, remove

the ground wire from the motor

housing (Figure 3) and relocate to

the screw below the motor gear

shown in Figure 4.

Ground wire location

Fig.3. Ground wire to be relocated.

Fig. 4. Ground wire relocated.