Owner Manual

4
TDM ENHANCEMENT KIT INSTALLATION PROCEDURES
12. Install the note and reject cassette.
Rotate the dispenser 180°
counterclockwise back to the
operate position. Installation of
the Enhancement kit is complete.
11. Pull the tie wrap taut until the cables
are secured in place. (Figure 12)
Fig. 9. Insert clip in hole provided.
Fig. 7. Feed tie wrap.
Tie wrap
openings
Fig. 8. Tie wrap started (loop).
Fig. 10. Route cables through clip.
Fig. 12. Power and data cable
secured with tie wrap.
Power cable
Data cable
Tie wrap
cables
Fig. 11.Route cables through tie wrap.
11. Reinstall the dispenser on the tray
and secure with the 4 screws.
Route the power and data cables
through the tie wrap loop and
connect to the dispenser board.
(Figure 11)
** IMPORTANT **
The power and data cables MUST be
secured to the dispenser with the tie
wrap provided. Failure to do so may
cause damage to the connectors and/
or cables.