Owner Manual

2
TDM ENHANCEMENT KIT INSTALLATION PROCEDURES
Introduction
The following describes how to install the protective plastic cover for the TDM
dispensing mechanism and associated hardware for 9100, 9705, and RL5000 (w/
TDM mechanism) ATMs.
PARTS AND TOOLS REQUIRED
Follow these steps to install/secure the protective plastic cover, cable clip, and
power/data cables to the dispenser..
1. Open the control panel hood. Turn
the power switch on the power
supply to the OFF (0) position.
2. Open the dispenser vault door.
Locate the spring-loaded locking
pin on the underside of the
dispenser tray. Pull pin down and
slowly turn the dispenser 180°
clockwise so the cassettes are
facing towards the front. Release
pin. (tray should lock in place) See
Figures 1 and 2.
3. Disconnect the power and data
cables from the dispenser.
Installing the TDM Enhancement kit for Model 9100 ATMs
Fig. 1. L ocation of locking pin.
Fig. 2. Turn mechanism clockwise.
DERIUQERSLOOT
revirdwercSspillihP1#
)mm6(6-TrevirDxroT
)mm01(01-TrevirDxroT
TIKTNEMECNAHNEMDT
57000-00260N/P
DEILPPUSSTRAP
REBMUNTRAPNOITPIRCSEDYTITNAUQ
51000-27030citsalP,dleihSIME1
78000-45020renetsaFTP,sulPxroT,mm6x5.2M,wercS2
20000-27030 * )0570-030KED(pilCnI-panS1
21000-27030 ** )0050-730KED(evisehdA,pilCeriWtalF2
51000-27030)BVU-R-81-TIWochciR(parWeiT''61
50100-41320daPlohoclA1
03000-00170serudecorPnoitallatsnItiKtnemecnahnEMDT1
:ETON* sledoM0019nodesU ** sledoM0005LR/5079nodesU