Owner Manual

ManualsBrandsTriton Systems ManualsOtherTDM

TDM 200/250

STiffener

BrackeT

inSTallaTion

TDN 07103-00198 June 19 2009

a registered trademark of Triton Systems of Delaware.

corporaTe HeaDquarTerS:

21405 B Street

Long Beach, MS 39560

Phone: (228) 575-3188

Fax: (228) 575-3200

Summary of content (4 pages)

PAGE 1
TDM 200/250 Stiffener Bracket Installation TDN 07103-00198 June 19 2009 Corporate Headquarters: 21405 B Street Long Beach, MS 39560 Phone: (228) 575-3188 Fax: (228) 575-3200 COPYRIGHT NOTICE © 2008 Triton. All Rights Reserved. TRITON logo is a registered trademark of Triton Systems of Delaware.
PAGE 2
TDM Stiffener Bracket Document Updates June 19 2009 Original Table of Contents Introduction Section 1 Purpose, Scope, Application, Parts & Tools...............................................pg 2 TDM Stiffener Bracket Installation ..........................................................pg 3 Purpose This guide covers the steps for installing a support bracket in the TDM. It helps support the upper double detect assembly area in the TDM 200/250 and resolves the problem of high rejects from Cassette A.
PAGE 3
TDM Stiffener Bracket Section 1 Installation Procedure - Follow the appropriate procedure to shut down your particular ATM and remove power. - Remove the reject and note cassettes. - In the upper cassette area, remove the 2 (two) screws and detent clips with the T20 torx driver. Retain the detents, discard the screws. Note the position of the mounting holes and right side indentation in this view. - Position the stiffener bracket in the rear of the lower cassette area as shown.
PAGE 4
TDM Stiffener Bracket - Using the new, longer screws, reinstall the detents as shown. It may take a little adjustment of the bracket to ensure engagement of the screws into the bracket. DO NOT over tighten the screws or you risk damage to the bracket or detents. The detents should not move. Note the relationship of the screw and detent. Ensure the detents face straight forward. - Replace the cassettes and return the ATM to service.