Owner Manual

TDN 07103-00172B
2
TDM ANTI-STATIC BRUSH KIT
INTRODUCTION
This page covers the steps for installing anti-static brushes for units listed that employ TDM dispensers (Model
9100/RL5000/RL2000). Brushes will be mounted to the bill tray assembly (inside cabinet door).
Lightly place/align the adhesive-backed brush on the bill chute flanges as shown below (brushes should be visible
through opening). Once aligned, apply pressure to the black-strip to seal/secure the static brush.
Anti-Static brush
Model 9100/RL5000
 If the bill tray looks like the one pictured below, place the anti-static brush on upper flange (centered,
brushes down)
Model RL2000
Place anti-static brush on lower bill tray shown in figures below (bottom flange - brushes up)
 If the bill tray looks like the one pictured below, place the anti-static brush across upper flange (brushes
down).
tiKhsurBcitatS-itnAMDT
)02100-00160N/P(
enoN:deriuqeRslooT
rebmuNtraP noitpircseD
50200-30040m5.11xmm051,citatS-itnA,hsurBm
27100-30170noitallatsnItiKhsurBcitatS-itnAMDT