Owner Manual

Triton Systems ©

    

1. Perform a proper shutdown of ATM via Management Functions > System Parameters > Shut Down the Termi-

nal.

2. When prompted, place the power switch on the power supply to the o (O) position.

3. Access the vault.

4. Using a No 2 phillips screwdriver, remove two screws securing dispenser to stationary tray. Retain for rein-

stallation.

5. Remove dispenser from vault and place on a at work surface.

6. Remove bracket and mylar tab from kit.

7. Install mylar tab onto grooved side of bracket. Ensure mylar tab is rmly seated within grooves and notch on

bracket.

8. Install bracket on dispenser by sliding bracket onto middle metal tab directly over the exit sensor. Mylar tab

should rest at an angle between the two belts.

MiniMech - Front

MiniMech - Back