Owner Manual

Triton Systems ©

    

**Note**

Service technician will need a rmware loader comloc and serial communication cable to complete this upgrade.

1. Perform a proper shutdown of ATM via Management Functions > System Parameters > Shut Down the Termi-

nal.

2. When prompted, place the power switch on the power supply to the o (O) position.

3. Access the vault.

4. Pull dispenser out to fully extended position.

5. Unplug dispenser power cable and communications cable. Detach ground wire if necessary and remove ca-

bles from cable clips, if necessary.

6. Grasp green handles on each side of dispenser and li straight up and o rails.

7. Place dispenser on at work surface or table.

8. Remove handles, then loosen the four screws securing the cover over the dispenser main board.

9. Slide cover up until notches clear the screws, then li away.