Owner Manual

Triton Systems ©

   

1. Perform a proper shutdown of ATM via Management Functions > System Parameters > Shut Down the Termi-

nal.

2. When prompted, place the power switch on the power supply to the o (O) position.

3. Access the vault.

4. Pull dispenser out to fully extended position.

5. Using a Torx T15 screwdriver, remove the two screws on each side that secure the front bracket. Retain for

reinstallation. Remove bracket from dispenser.

6. Using a No. 2 Phillip’s screwdriver, remove the two screws securing the static brush to the front of bracket.

Retain screws and static brush for reinstallation

7. Remove new front bracket from upgrade kit.

8. Install static brush onto new front bracket with screws removed in step 6.

9. Using a Torx T15 screwdriver, loosen screw on tab opposite the static brush until the screw, washer, and plate

can be removed from bracket.

10. Remove the black mylar tab from tape on the underside of bracket and align on tab.

11. Using a Torx T15 screwdriver, replace screw, washer, and plate so that black mylar tab is installed between

tab and plate.