Owner Manual

Triton Systems ©
37
39. Install the small belt removed in step 20.
40. Replace upper portion of dispenser, ensuring tabs slide into notches.
41. Using a Torx T20 screwdriver, install two screws removed in step 10 on each side of dispenser along the top
edge of the upper feed channel.
42. Plug in the following cable harnesses:
— CAN com to rst feeder at upper NFC board
— NFC power cable at upper NFC board
— Dispenser power cord at power supply
— Note stacker stepper motor cable at motor
— All connections at CMC board
1. Power PS CMC
2. Main motor
3. NS step motor
4. BOU sensor
5. BCU motor
6. RV CAN com
7. BCU Reject position sensor
8. BCU Delivery position sensor
9. BCU Home position sensor
10. NS position sensor
11. NS entry sensor
12. Transport clock sensor
13. Double detect sensor
14. ND motor
15. SP diverter motor
16. CAN com to rst feeder (NQ)
17. Not used
18. Not used
19. Communication RS 232
20. Shutter interface