Owner Manual

Triton Systems ©
36
32. Insert mechanical sensor base and snap down over gold t-bar.
33. Gently place spring from upgrade kit into round opening on mechanical sensor base.
34. Remove lever arm from upgrade kit and route hooked end through the opening between wheel and mechan-
ical sensor so that hooked end rests under metal axle of wheel assembly.
35. Notch on opposite end of lever arm will rest in the top of spring and round tabs of lever arm will align with
notched opening in center of mechanical sensor.
36. Once lever arm is aligned, press rmly in center over round tabs until lever snaps into mechanical sensor
base.
37. Install the note stacker timing wheel cover, then tighten the three screws on the note stacker motor that were
loosened in step 22.
38. Install note stacker onto dispenser by sliding back until tabs lock into place.