Manualshelf

Owner Manual

ManualsBrandsTriton Systems ManualsOtherTDM
31323334353637383940
Triton Systems ©
33
** Note **
Only Rev 5 boards can be used for this upgrade. Ensure new NFC boards are Rev 5.
14. Remove new NFC board from upgrade kit.
15. Slide NFC board into place on dispenser and install screw removed in step 13 to secure NFC board. Ensure
any necessary ground wires are reattached.
16. Repeat steps 13-16 to replace NFC board in channel 2 and for any additional channels.
17. Using a Torx T20 screwdriver, remove two screws on each side of dispenser along the top edge of the upper
feed channel.
NFC
NFC
18. Insert at head screw driver into slot beside screws and gently press tabs until top section of NMD is loos-
ened.
19. Remove top portion of NMD 100 and set aside.
20. Remove small belt on note stacker.