Owner Manual

Triton Systems ©
32
9. Unplug the following cable harnesses:
— CAN com to rst feeder at upper NFC
board
— NFC power cable at upper NFC board
— Dispenser power cord at power supply
— Note stacker stepper motor cable at motor
— All connections at CMC board
10. Using a Torx T10 screwdriver, remove three screws from CMC board. Retain for reinstallation. Note any
ground wires that are unattached during screw removal.
** Note **
Only Rev 3 boards can be used for this upgrade. Verify new CMC board is a Rev 3.
11. Remove new CMC board from upgrade kit.
12. Slide CMC board into place on dispenser ensuring hole in CMC board mounts onto stud on dispenser. In-
stall screws removed in step 10 to secure CMC board. Ensure any necessary ground wires are reattached.
13. Using a Torx T10 screwdriver, remove screw from top of NFC board on channel 1. Retain for reinstallation.
Note any ground wires that are unattached during screw removal.