Owner Manual

Triton Systems ©

13. Using a Torx T10 screwdriver, remove screw from top of NFC board on channel 1. Retain for reinstallation.

Note any ground wires that are unattached during screw removal.

NMD 50

NFC

CMC

** Note **

Only Rev 5 boards can be used for this upgrade. Ensure new NFC boards are Rev 5.

14. Remove new NFC board from upgrade kit.

15. Plug cable harnesses into new NFC board.

16. Slide NFC board into place on dispenser and install screw removed in step 13 to secure NFC board. Ensure

any necessary ground wires are reattached.

17. Repeat steps 13-16 to replace NFC board in channel 2 and for any additional channels.

18. Replace handle assembly. Use screws removed in step 7.

19. Install dispenser into vault.

20. Plug in power and communications cables, then power on ATM.

21. Reset dispenser to factory defaults via Management Function > Diagnostics > Dispenser > Reset Dispenser to

Factory Defaults.