Owner Manual

Triton Systems ©

8. Disconnect cable harnesses from CMC board.

9. Using a Torx T10 screwdriver, remove screw from top of CMC cover. Retain for reinstallation. Note any

ground wires that are unattached during screw removal.

NMD 50

NFC

CMC

** Note **

Only Rev 4 boards can be used for this upgrade. Verify new CMC board is a Rev 4.

10. Remove new CMC board from upgrade kit.

11. Plug cable harnesses into new CMC board.

12. Slide CMC board into place on dispenser and install screw removed in step 9 to secure CMC board. Ensure

any necessary ground wires are reattached.