Owner Manual

Triton Systems ©

    

1. Perform a proper shutdown of ATM via Management Functions > System Parameters > Shut Down the Termi-

nal.

2. When prompted, place the power switch on the power supply to the o (O) position.

3. Access the vault.

4. Pull dispenser out to fully extended position. Identify dispenser revision. Revision ID plate is located on met-

al frame under cassette in the top feed channel.

5. Unplug dispenser power cable and communications cable.

6. Li dispenser o tabs or remove from slide rails. Place dispenser on a at surface.

7. Remove handle assembly from main board side of dispenser by removing screws securing handle to frame

with a Torx T20 screwdriver. e tabbed handle has ve screws and the railed handle has three screws.