Owner Manual

Triton Systems ©
17
   
A serial communication cable (p/n 09120-00923) is required to download the rmware from the PC to the serial
CDU dispenser. If your PC does not have a serial port, you will also require a USB-to-serial adapter. Both parts
are readily available at local electronics stores.
**Note**
Screen shots are indicative of what should be seen during the load process. Firmware versions and actual screens
may vary.
1. Perform a proper shutdown of the ATM via Management Functions > System Parameters > Shut Down the
Terminal.
2. When prompted, place the power switch on the power supply to the o (O) position.
3. Access the vault.
4. Unplug dispenser power cable and communications cable.
5. Remove four screws securing dispenser to tray within vault. Retain for reinstallation.
6. Remove dispenser from vault.
7. Place dispenser on a at work surface or table if removed from unit.
8. Loosen the four screws securing the cover over the dispenser main board.
9. Slide cover up until notches clear the screws, then li away.