Owner Manual

Triton Systems ©
13
  
30. Flip dip switches 1, 3, and 4 to the ON position. Press the reset button below the switches to put the dispens-
er into dispense mode.
31. Replace cover over dispenser main board, and tighten the four screws to secure, then install handles.
32. Remove cassettes from dispenser.
33. If using old cassettes, adjust cassette width rails where necessary. Rail location is dependent on denomina-
tion of new Australian polymer bank note being loaded into cassette. If using new Australian polymer-ready
cassette, verify width rails are in correct location.
Bank Note Width Directions
AUD $5 145 mm Loosen two screws on each width rail.
Slide rails to center position.
Tighten two screws on each width rail to secure.
AUD $10 TBA TBA
AUD $20 TBA TBA
AUD $50 TBA TBA
AUD $100 TBA TBA
34. Load or replenish bank notes in cassettes. Close and lock cassettes.
35. Install cassettes in dispenser.
36. Grasp green handles on either side of dispenser and lower dispenser onto slide rails. Ensure dispenser seats
onto round tabs on the slide rails.