Owner Manual


Page1of31

InstallingtheTDMCassettePresentSensorwithSecuritySwitch
BeforestartinginstallationofTDMFirmwareLoaderv16.03RevC,theTDMCassetteSensorwith
SecuritySwitchmustbeinstalled.
AlwaysperformapropershutdownofATMbeforeservicingtheTDMmechanism.
TDM200/250
ToolsNeeded:
‐ T6Driver

Step1–Extendthedispenserslidestothefullextension(ifapplicable).Pullthereleasepindownonthe
bottomoftrayandrotatethetrayclockwise180°.Locatetheuppercassettepresentsensorboardon
thenon‐beltsideofthedispenser.NOTE:NotallATMshaveslidingorro
tatingtrays.



Step2–Unplugbothcablesfromthesensorboard.UsingaT6driver,removethescrewsecuringthe
sensorboardtothedispenser.
