Manualshelf

Owner Manual

ManualsBrandsTriton Systems ManualsOtherTDM
12
2
TDM-100/150 DETENT CLIP REPLACEMENT PROCEDURES
TDN 07103-00169
2. Remove the note and reject cassettes. Using the #20 Torx L-key provided, remove the screws and detent clips
shown.
3. Install the provided detent clips (gray) and secure (hand-tighten) with the screws included with the Torx L-key.
Note the position of the detent clip when installed (flange facing up on backside).
4. Reinstall the note and reject cassettes. You should hear an audible “click” when the note cassette is fully inserted.
Rotate the dispenser back counterclockwise to the “Operate” position.
Flange
Detent clips