Owner Manual

TDM-100/150 BASE PLATE UPGRADE PROCEDURES

REPLACING THE BASE PLATE, DETENT CLIPS, DIVERTER FASTENERS

The following procedures apply to both TDM dispensers (100/150). The TDM-150 has two (2) additional torx screws that have to

be removed from each side. The following steps will reference the TDM-100.

TDM-100

TDM-150

Figure 2. Torx/phillips screws location.

1. Place the dispenser on its side as shown in Figure 1. Using the #20 torx driver, remove the three (3) bottom torx screws. Set

screws aside.

2. Turn the dispenser over on its other side as shown in Figure 2. Remove the two (2) bottom torx screws. Set screws aside. Using

a phillips screwdriver, remove the two (2) phillips screws that secure the belt cover and grounding harness. Remove the belt

cover and set screws aside.

Figure 1. Torx screws location.

3. Turn the dispenser over so that the bottom plate is facing up as shown in Figure 3. Remove the bottom torx screw shown. Set the

screw aside.

Figure 3. Bottom Torx screw location.

Note

This screw is slightly different from the other ones

removed. When reassembling the new base plate,

ensure this screw is placed in the proper location.

Belt cover