Owner Manual

3
TDM-100/150 BASE PLATE UPGRADE PROCEDURES
Figure 1. Pull release pin for swivel platform.
2. Pull the pin down to release the swivel mounting platform. Slowly turn the tray clockwise so that the note and reject cassettes
can be accessed from the front. Release the locking pin and move the mounting platform back and forth slightly to ensure the
pin snaps back into place, locking the mounting platform into the service position (Figures 2 and 3).
1. Open the cabinet vault door. Rotate the dispensing mechanism mounting platform to the service position. To do this, locate the
spring-loaded locking pin on the underside of the mounting tray. This pin lets you lock the dispenser’s swivel mounting platform
into half-turn access positions. (Figure 1)
3. Disconnect the power and communication (Comms) cables from the dispenser (Figure 4). Open the ferrite component that
surrounds the 2 cables and set aside.
Note: Before proceeding, follow the proper shutdown procedures to remove power from the ATM:
REMOVING THE TDM FROM A FIXED TRAY
4. Remove the note and reject cassettes. Using a phillips head screwdriver, remove the four (4) screws that secure the dispenser to
the swivel platform (Figure 5). Remove the TDM dispenser mechanism and place on a flat surface.
Figure 2. Rotate dispenser clockwise.
Figure 3. Mechanism in service position.
Figure 4. Power and Comm cable disconnected.
Figure 5. Remove mounting screws.