Owner Manual

ManualsBrandsTriton Systems ManualsOtherTDM

TDM-100/150 BASE PLATE

UPGRADE PROCEDURES

TDN 07100-00078 04/2007

CORPORATE HEADQUARTERS: RMA (RETURN MATERIAL AUTHORIZATION)

RETURN A DDRESS:

522 E. Railroad Street 21405 Avenue “B”

Long Beach, MS 39560 Long Beach, MS 39560

Phone: (228) 868-1317

Fax: (228) 868-0437

operating company of Dover Electronics, Inc., a subsidiary of Dover Corporation (NYSE-DOV).

DOVER, the DOVER logo and the family of marks and TRITON, the TRITON logo and the Triton

family of marks are registered trademarks of Delaware Capital Formation, Inc., a wholly owned sub-

sidiary of Dover Corporation.

Summary of content (6 pages)

PAGE 1
TDM-100/150 BASE PLATE UPGRADE PROCEDURES TDN 07100-00078 CORPORATE HEADQUARTERS: 522 E. Railroad Street Long Beach, MS 39560 Phone: (228) 868-1317 Fax: (228) 868-0437 04/2007 RMA (RETURN MATERIAL AUTHORIZATION) RETURN ADDRESS: 21405 Avenue “B” Long Beach, MS 39560 COPYRIGHT NOTICE © 2007 Delaware Capital Formation, Inc. All Rights Reserved. Triton Systems of Delaware, Inc. is an operating company of Dover Electronics, Inc., a subsidiary of Dover Corporation (NYSE-DOV).
PAGE 2
TDM-100/150 BASE PLATE UPGRADE PROCEDURES PURPOSE This guide covers the steps for replacing the TDM-100/150 dispenser base plate, detent clips, and access panel fasteners. This procedure includes a list of all tools and hardware necessary for the upgrade as well as the steps involved. SCOPE This procedure applies to all service personnel involved in the process of maintaining or converting Triton ATMs.
PAGE 3
TDM-100/150 BASE PLATE UPGRADE PROCEDURES REMOVING THE TDM FROM A FIXED TRAY Note: Before proceeding, follow the proper shutdown procedures to remove power from the ATM: 1. Open the cabinet vault door. Rotate the dispensing mechanism mounting platform to the service position. To do this, locate the spring-loaded locking pin on the underside of the mounting tray. This pin lets you lock the dispenser’s swivel mounting platform into half-turn access positions. (Figure 1) 2.
PAGE 4
TDM-100/150 BASE PLATE UPGRADE PROCEDURES REMOVING THE TDM FROM A SLIDE TRAY Note: Before proceeding, follow the proper shutdown procedures to remove power from the ATM: 1. Open the cabinet vault door. Release the locking slide rail and fully extend the dispenser from the cabinet (Figure 1). Rotate the dispensing mechanism mounting platform to the service position. To do this, locate the spring-loaded locking pin on the underside of the mounting tray (Figure 2).
PAGE 5
TDM-100/150 BASE PLATE UPGRADE PROCEDURES REPLACING THE BASE PLATE, DETENT CLIPS, DIVERTER FASTENERS The following procedures apply to both TDM dispensers (100/150). The TDM-150 has two (2) additional torx screws that have to be removed from each side. The following steps will reference the TDM-100. TDM-100 TDM-150 1. Place the dispenser on its side as shown in Figure 1. Using the #20 torx driver, remove the three (3) bottom torx screws. Set screws aside. 2.
PAGE 6
TDM-100/150 BASE PLATE UPGRADE PROCEDURES 4. Turn the dispenser on its side and remove the existing base plate from the dispenser. Note If the plate is hard to remove, open the bottom access door located in Figure 4. Loosen the torx screw shown and base plate should release from dispenser. 5. Using the #20 torx driver, install the new detent clips (gray) to the new base plate with the screws provided (Figure 5). Hand-tighten screws! 6.