Owner Manual

ManualsBrandsTriton Systems ManualsOtherTDM

TDM DRIVE BELTS

FIELD REPLACEMENT PROCEDURES

TDN 07100-00057 03/2006

ORPORATE HEADQUARTERS: RMA (RETURN MATERIAL AUTHORIZATION)

RETURN ADDRESS:

522 E. Railroad Street 21405 Avenue “B”

Long Beach, MS 39560 Long Beach, MS 39560

Phone: (228) 868-1317

Fax: (228) 868-0437

FROM, TRITON WAVES, DOVER and the DOVER logo are registered trademarks of Delaware Capital For-

mation, Inc., a wholly-owned subsidiary of Dover Corporation.

Summary of content (6 pages)

PAGE 1
TDM DRIVE BELTS FIELD REPLACEMENT PROCEDURES TDN 07100-00057 03/2006 CORPORATE HEADQUARTERS: RMA (RETURN MATERIAL AUTHORIZATION) RETURN ADDRESS: 522 E. Railroad Street Long Beach, MS 39560 Phone: (228) 868-1317 Fax: (228) 868-0437 21405 Avenue “B” Long Beach, MS 39560 COPYRIGHT NOTICE © 2006 Delaware Capital Formation,Inc. All Rights Reserved. TRITON, TRITON WHERE MONEY COMES FROM, TRITON WAVES, DOVER and the DOVER logo are registered trademarks of Delaware Capital Formation, Inc.
PAGE 2
TM TECHNICAL BULLETIN TECHNICAL BULLETIN # 5-65 DATE: November 1, 2005 SUBJECT: TDM-100 and TDM-150 Modified in the RL5000 Product Line APPLICABILITY: All Authorized Triton Distributors and Third Party Service Providers This bulletin addresses: Documentation Changes X Hardware Service Issues Software Announcements Technical Tips Recommended Implementation is: Now for all affected units X All affected units during next service visit Optional No implementation required There are two versions of TDM-1XX d
PAGE 3
TM NOTE: Triton recommends that all terminals operate with the latest version of software to take advantage of improvements in performance or added features new software may offer. A quick visual check of the drive motors can help determine the dispenser type and is illustrated in the photos below. The original TDM dispenser will have a black encased stepper motor installed next to the dispenser mainboard. The DC Drive motor on the TDM Modified is silver in color.
PAGE 4
TDM DRIVE BELTS FIELD REPLACEMENT PROCEDURES INTRODUCTION This guide covers the steps for field replacement of the upper drive and diverter belts for TDM dispensing mechanisms. The kit required is determined by the type motor installed on the mechanism. The tables below list the belt replacement kit needed for motor type and the specific mechanisms. Note: The DC motor type (not Stepper) has a timing wheel for the driver motor.
PAGE 5
TDM DRIVE BELTS FIELD REPLACEMENT PROCEDURES NOTE: Remove power from the terminal before proceeding! These procedures require the mechanism be removed from the ATM. c Remove belt cover by loosening the phillip-head screws or Torx screws, if applicable. Belt cover Belt cover TDM-250 w/Billfish TDM-100 d Disengage the Drive Motor belt FIRST by removing from the top pulley (long belt). Upper belt Drive motor belt Belts locations e Drive motor belt Next, remove the Upper belt (small belt).
PAGE 6
TDM DRIVE BELTS FIELD REPLACEMENT PROCEDURES f After Upper belt is removed, remove the Drive Motor belt off the inside pulley. Belts removed g Reversing the process, install the Drive Motor belt FIRST on the inside pulley (long belt). h Next, install the Upper belt (small belt). Start belt on pulleys. Slightly “squeeze” the 2 pulleys and roll Drive motor belt on inside pulley belt/pulley until belt is installed. Roll Upper belt to install on pulleys.