Owner Manual

TDM FIRMWARE UPDATE PROCEDURES
3
Step 3: Install the upgraded (dual) power supply provided
following the steps in reverse. Reconnect all cables
Except
the TDM power cable
Step 4: Connect one end of the adapter cable (P/N 09120-
07032) to the TDM power cable. Connect the other end of the
adapter cable to the power supply (largest molex connector
on power supply).
RT2000
Step 1: ENSURE POWER SWITCH IS OFF! Disconnect
all the cables (AC and DC) from the power supply.
Step 2: Using an 11/32" nut driver, loosen the two (2) bot-
tom nuts shown. Next, lift the power supply up and remove.
Step 3: Install the upgraded (dual) power supply provided
following the steps in reverse. Reconnect all cables Except
the TDM power cable
Step 4: Connect one end of the adapter cable (P/N 09120-
07032) to the TDM power cable. Connect the other end of the
adapter cable to the power supply (largest molex connector
on power supply).
Power switch
TO TDM POWER CABLE
TO POWER SUPPLY
TO TDM POWER CABLE
TO POWER SUPPLY