Owner Manual

POWER SUPPLY UPGRADE

RL5XXX & RT2XXX

TDN 07103-00163 March 14, 2014

registered trademark of Triton Systems of Delaware, LLC

Corporate Headquarters

21405 B Street

Long Beach, MS 39560

Phone: (800) 259-6672

Fax: (228) 868-9445

PAGE 1
POWER SUPPLY UPGRADE RL5XXX & RT2XXX TDN 07103-00163 March 14, 2014 Corporate Headquarters 21405 B Street Long Beach, MS 39560 Phone: (800) 259-6672 Fax: (228) 868-9445 COPYRIGHT NOTICE © 2014 Triton. All Rights Reserved.
PAGE 2
TDM FIRMWARE UPDATE PROCEDURES INTRODUCTION This guide covers the steps for upgrading an RL/RT terminals power supply from single to dual. This upgrade applies to these terminals equipped with TDM dispensing mechanisms. An additional procedure for loading a TDM firmware update file is also required after the power supply upgrade. This procedure and firmware software is located on the Software CD, document 0710300168B.
PAGE 3
TDM FIRMWARE UPDATE PROCEDURES Step 3: Install the upgraded (dual) power supply provided Step 4: Connect one end of the adapter cable (P/N 09120- following the steps in reverse. Reconnect all cables Except the TDM power cable 07032) to the TDM power cable. Connect the other end of the adapter cable to the power supply (largest molex connector on power supply).