Guide

47
OPERATOR SERVICE PANEL INSTALLATION
6. Connect the data cable (RJ-45
connector end) to the OSP shown
in Figure 3. Ensure the other end
of cable is connected to the
“Auxillary” port on the docking
board.
Figure 3. OSP mounted and
cable connected.
WARNING:
Inspect the Mounting Bracket Studs and RSP Mounting Holes closely.
Note the studs have grooves provided for the RSP to mount onto. Ensure
the RSP sets down onto the studs properly on all 3 (three) mounting points.
Failure to do so may allow the RSP to become dislodged, which may
cause physical and electrical damage to the RSP and possibly personal
injury.