Owner Manual

28
MODEL RT2000 (X2) INSTALLATION GUIDE
TCP/IP (ETHERNET)

capable. The ATM functions that are normally performed via the dial-up telephone system, such as customer
transactions and remote monitoring, can be performed using existing in-house communications network.
ATM transaction processing and hardware monitoring functions are performed across a shared network
medium. Ethernet is popular because it strikes a good balance between speed, cost and ease of installation.
TCP/IP CABLE (CAT-5) CONNECTIVITY
1. If the unit is ON, enter MANAGEMENT FUNCTIONS > SYSTEM PARAMETERS > SHUT DOWN THE TERMINAL.

supply to the OFF (0) position.
2. Refer to the section on “Power and Communication”. Route the 10Base-T (CAT-5) cable through
the cabinet base cable access hole. Secure cable inside vault area and continue up to the control panel
access holes.
3. Connect the RJ-45 end of CAT-5 cable to the TCP/IP connector located on the X2 M
AIN BOARD

 
Ethernet options.
USB PORTS
RJ-45 (CAT-5)
TCP/IP P
ORT