Owner Manual

23
MODEL RT2000 (X2) INSTALLATION GUIDE
SEALING THE CONTROL PANEL TRIM
To ensure that the temperature around the unit is maintained during cold weather, it’s important that the wall

between the ATM and the inside wall opening should be left clear to allow air to circulate at room tempera-
ture. After the control panel trim is installed, a good weather seal is needed between the exterior wall
and the trim. A suitable water -resistant sealant product is required around the periphery of the control
panel trim. There are also products that are color tinted to closely match the trim color.
**IMPORTANT**
SEAL THE TRIM TO THE EXTERIOR WALL WITH A WAT ER -RESISTANT SEALANT TO
PREVENT WATER INTRUSION. DO NOT SEAL AROUND THE BOTTOM OF THE TRIM!
SMALL DRAIN HOLES ARE LOCATED ON THE UNDERSIDE THAT MUST BE CLEAR!
Control panel trim sealed.
