Owner Manual

MODEL RT2000 (X2) INSTALLATION GUIDE

INSTALLING / SECURING CONTROL PANEL TRIM

2. (Reference previous steps for mounting control panel trim) Align the trim clips with the sleeve slots

and insert until the trim is seated on the control panel.

1. Loosen the three (3) thumbscrews on the backside of the fascia trim hardware. Loosen until the ends



3. Once the trim is in place, open the rear cabinet door. To secure the fascia trim:

Five (5) screws (K40x12 - included in accessory kit) and the three (3) thumbscrews (pictured above)

need to be secured. First, tighten the three (3) thumbscrews toward the bottom of the control panel lip



Note: Picture below shows 3 of the 5 screw holes. The other 2 are located in line to the left.

Three (3) thumbscrew.

Screw locations.

Tighten thumbscrew to secure bottom .