Owner Manual

MODEL RT2000 (X2) INSTALLATION GUIDE

ADJUSTING HEIGHT/LEVEL OF UNIT

Triton Systems offers two (2) metal-constructed optional plinths w/leveling feet. The

plinths come in 2 heights: 3” (76 mm) and 6” (152 mm - shown below). Based on the

height requirement needed, you can either:

1) Raise the unit with the leveling feet installed in the cabinet (Business Hours

and Level 1) using a 1/4” (6mm) nut driver/socket.

(Caution: The leveling feet are primarily for that purpose - leveling the ATM, not to

raise the unit by more than 3/4”).

2) Construct your own plinth. A “plinth” is a platform on which the ATM rests or is

secured. This plinth enables the ATM to be installed at the required height through the

wall. If built, it must be no smaller than the base of the cabinet and must be constructed

of a material that is capable of supporting the weight of the ATM.

3)

needed, adjust up using the plinths leveling feet (adjustable crescent wrench required).

Caution: Leveling feet are primarily used for leveling the ATM, not to raise the unit

by more than 3/4”.

4) “Stack” the optional plinths. Before securing two (2) plinths together, remove the

leveling feet from the top plinth.

c Leveling feet

d Anchor holes

e Cabinet/Stack holes